KIT VB SEMIAIR COMFORT AIR SUSP. 8"W/PRESSURE GAUGE

VB-SemiAir AIR SUSPENSION

The VB-SemiAir suspensions, manually adjustable within certain limits, can be installed on vehicles with leaf springs.
The pneumatic bellows, mounted between the chassis and the rear axle, support the existing leaf springs and, not being connected to each other, allow the left and right sides to be adjusted separately via two filling valves/switches (depending on the model ).
The VB-SemiAir double chamber system thus ensures vehicle stabilization even in the event of uneven load distribution.
The valves (for the basic kit) / the high/low switches (for the comfort kit) allow optimal inflation of the pneumatic bellows, thus allowing the vehicle’s ride level to be raised or lowered.

Advantages of VB-SemiAir:

• Higher gear level and greater spring travel.
• Greater stability.
• Less stress on the shock absorbers.
• Lower risk of asymmetric position thanks to the double chamber system.
• Variable elastic force.
• Quick installation thanks to the plug-and-play system.
• Protection from damage to bodywork, equipment and cargo.
• Heavy loads not visible from the outside.

VB-SemiAir comfort system

The VB-SemiAir comfort system consists of a VB-SemiAir basic system with control panel with 2 pressure gauges, 2 high/low switches and a powerful high-performance compressor.

The high/low switch allows you to increase or decrease the vehicle’s ride level to be able to inflate the pneumatic bellows to the ideal pressure. Pressure gauges ensure an accurate reading of the pressure (in bar) in the pneumatic bellows.

The VB-SemiAir comfort system is a good solution for vehicles carrying variable loads. The control panel with high/low switch allows you to adjust the VB-SemiAir system to the correct pressure.

The control panel for the VB-SemiAir comfort system is available in two versions:

Light commercial vehicles – Control panel mounted on the driver’s seat
Camper – Control panel mounted in the dashboard of the vehicle

The VB-SemiAir Comfort kit consists of:

• 2 x 8″ pneumatic bellows
• 1 pressure gauge kit (seat or dashboard based on request),
• 1 compressor
• 2 high/low switches
• 1 harness
• 2 brackets
• 2 tubes
• 1 set of fasteners.